common mistakes when laying laminate flooring

Laminate flooring is growing to be one of the most popular options in the US recently. We’ll discuss here the common mistakes of the same, including click lock flooring problems, laminate flooring level tolerance, hot to fix laminate flooring that is lifting, laminate flooring installation tips, laying laminate flooring tips, etc. Read on to know more.

Flooring laminate must float

The installer gets relaxed sometimes and forgets this simple law. Depending on the product, an expansion of 1⁄4' to 3/8' is required for all vertical obstructions, including door frames and each transition strip. Door Frames: When undercutting door frames, ample space for expansion should be checked by the installer. This will demand that the sheetrock be cut back. The baseboard must also be cut back about an inch from the casing. In both directions, this will give the floor space to expand or contract.

Transition strips: When an installer uses construction adhesive to secure the strip to the subfloor, transition strips become troublesome. It oozes on the flooring if too much adhesive is used and traps the entire floor in its place. Silicone is a good adhesive and stays flexible if it is required to use an adhesive to protect the subfloor. We suggest using the included track. We suggest screwing the track down on timber subfloors.

Flatness of Floor

In installations, floor flatness can also be a concern. Installation over an uneven subfloor could lead to excess motion that could lead to gaping and eventual breakage. Some planning is expected of all subfloors. Industry specifications state that the subfloor surface must be level to within 10-ft of 3/16'. Uh, radius. Laying a straight edge over the floor will check the flatness to identify the high and low spots. It's necessary to ground all high spots down. It is recommended to use Portland-based leveling compounds approved for this application to fill low spots in the subfloor. Before proceeding with installation, allow the patching compound to dry thoroughly. Consider making use of a patch for self-drying. Never use additional foam underlay layers to cover voids, too.

Moisture Subfloor

The moisture content of the subfloor is another concern to be tested before installation. For laminate, the moisture content of the subfloor is just as important as it is for hardwood floors. High humidity in the subfloors will cause the laminate seam to the peak. Laminate flooring has a hygroscopic heart, which means it retains moisture. Laminate floors can expand or contract as the moisture content increases, similar to hardwood floors. Until installation, all subfloors must be tested, and I suggest recording these measurements for future reference. The fresh concrete must be cured and then tested for at least 60 days. Cover all concrete slabs with a 6-mil polyethylene non-recycled resin film as a vapor retarder, regardless of grade level.

Have a fun time installing laminate flooring!